Securing the Charging Station

This kit provides washers and screws for securing a charging tray to a table or other surface. Use two kits for the NCS8. Please refer to the NCS mounting template for screw hole placement.

Important: The top of the screw must extend exactly ⁹/₆₄ (0.149) inches (3.78 mm) above the surface (about 4½ threads).

  • Use the screws that best fit the thickness of the table.
  • Use a lock washer and flat washer for each screw.
  • If necessary, counterbore the screw head or add additional flat washers.

Required Thread Exposure

Use counterbore and washers as necessary depending on thickness of table

NCS Mounting Template