 |
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. |
 |
This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. |
Caution: Do not transport chargers with batteries inserted.
Warning: Do not charge batteries in enclosed spaces without proper ventilation.
The SBC203 two-bay charger holds two SB903 batteries or compatible transmitters. It may be used in any appropriate location with adequate space and ventilation.
Note: SB903 batteries not included.
To save space and reduce clutter, chargers can be linked together using the provided hardware. Line up the bottom indentation on the chargers to be linked and attach the bottom plate using the provided screws. Once linked, chargers can be moved as one piece of hardware.
Note: Each charger requires an independent power supply.
To charge, place batteries into the charging bays with slotted sides down, or insert transmitters into the charging bays with the display facing forward. The LEDs illuminate to indicate battery status.
IMPORTANT: Always insert transmitters facing forward to avoid damage
| Description | Color | State |
|---|---|---|
| Ready for Use | Green (solid) | Device is fully charged |
| Charging | Red (flashing) | Charging |
| Error | Yellow (quick flashing) | Battery or power supply error* |
| Yellow (slow flashing) | Outside of operating temperature range | |
| Not charging | Off | Power supply is disconnected, or no device is docked in the charging bay |
* If an error occurs when a transmitter is docked in the charger, remove the battery from the transmitter and place directly into the charger. If the error persists, contact Shure Technical Support.
Note: Store batteries in the charger or in a proper container. To protect terminals from shorting, DO NOT place batteries in a box or pocket with metal objects such as nails, screws, or keys.
625 mA or 250 mA
Lower current used when using another power source, or operating between 0℃ and 10℃
50% = 1 hour : 15 minutes; 100% = 2 hours : 30 minutes
SBC10-USB15W or SBC10-USB15WS
5 V DC, 3 A max.
0 °C to 45 °C (32 °F to 113 °F)
66 x 99 x 165 mm (2.6 x 3.9 x 6.5 in.), H x W x D
284 g
ABS
100 to 240 V AC
50 Hz to 60 Hz
0.6 A
at 100 V AC full load
4.75 to 5.25 V DC
3.0 A
at 5 V
0 °C to 60 °C (32 °F to 140 °F)
This device complies with Part 15 of the FCC Rules.
Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equipment.
Please consider the environment, electric products and packaging are part of regional recycling schemes and do not belong to regular household waste.
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
Publications