|This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.|
|This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.|
Explanation of Symbols
|Caution: risk of electric shock|
|Caution: risk of danger (See note.)|
|Equipment protected throughout by DOUBLE INSULATION or REINFORCED INSULATION|
|Equipment should not be disposed of in the normal waste stream|
WARNING: Danger of explosion if incorrect battery replaced. Operate only with AA batteries.
Please follow your regional recycling scheme for batteries, packaging, and electronic waste.
This product has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instruction manual, may cause harmful interference with radio communications. Operation of this product in a residential area is likely to cause harmful interference, in which case you will be required to correct the interference at your own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Notice: The FCC regulations provide that changes or modifications not expressly approved by Shure Inc. could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in a non-residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference with radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:
Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equipment.
For information regarding responsible party and other matters relating to FCC compliance, please contact Shure Incorporated, 5800 W. Touhy Avenue, Niles, Illinois 60714-4608 U.S.A. shure.com/contact
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
The SBC210LM's interchangeable charging modules provide a compact desktop charging station for a range of Shure Lithium-ion batteries.
Exterior of the portable rechargeable battery housing
② Charging Bay
Align and insert compatible charging module
③ Captive Screw Holes
Four internal threaded screw holes to secure charging module in place
④ DC Power Supply Input
Connect a compatible power supply
⑤ Charging Module
Compatible charging modules can be swapped as needed (modules sold separately)
The SBC210-LM supports the following Shure charging modules and Lithium-ion rechargeable batteries:
|Mounting Screws for Charger Modules (8)||30B13476|
|SBC-AX Charging Module for SB900B||SBC-AX|
|SBM910 Charging Module for SB910||SBM910|
|SBM910M Charging Module for SB910M||SBM910M|
|SBM920 Charging Module for SB920 and SB920A||SBM920|
Slide the battery into the charging bay until it locks into place. The charge LED illuminates and the charge cycle begins.
Each charger bay has an LED to indicate the status of the battery.
|Off||battery inserted incorrectly or battery depleted below 3.0 volts.|
|Amber||charging stopped at reduced capacity (not less than 75% capacity) because the battery is too warm. To reach 100% capacity, a battery must be cooled to below 45°C.|
A deeply discharged battery is one that has been discharged to less than 3.0 volts. When the charger detects a deeply discharged battery, it automatically enters recovery mode, which charges the battery using a reduced current. A red LED indicates recovery mode. If recovery is successful, the charger exits recovery mode and charges the battery to capacity. If the battery cannot be recovered in less than 30 minutes, the red LED turns off and charging stops.
Caution! Remove DC power and remove batteries when installing the charging module.
|Power LED off.||DC power fault - check connection to power supply. Ensure PS51 power supply is connected to an AC power source.|
|Charge status LED does not illuminate.||Battery is not fully inserted.|
|Battery does not charge||Battery discharged below 3.0 volts. Try another battery.|
Up to 2 rechargeable Li-Ion batteries (SB900B, SB910, SB910M, SB920, SB920A)
50%=1.5 hours; 100%=3.5 hours
-18°C (0°F) to +40°C (104°F)
0°C (32°F) to 60°C (140°F)
-29°C (-20°F) to 74°C (165°F), without batteries
44 x 86 x 116 mm (1.8 x 3.4 x 4.5 in.), H x W x D
425 g (15.0 oz.), without batteries or PS51 External Power Supply
Cast and extruded aluminum
|Input||5.5 V DC, 2.72 A maximum|
|Output||4.2 V DC, 1.2 A maximum|
Conforms to electrical safety requirements based on IEC/EN 62368-1.
Authorized under the verification provision of FCC Part 15A.
Meets essential requirements of the following European Directives:
Please follow your regional recycling scheme for battery disposal.
CE Notice: Hereby, Shure Incorporated declares that this product with CE Marking has been determined to be in compliance with European Union requirements. The full text of the EU declaration of conformity is available at the following site: https://www.shure.com/en-EU/support/declarations-of-conformity.
Authorized European representative:
Shure Europe GmbH
Department: Global Compliance
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
UKCA Notice: Hereby, Shure Incorporated declares that this product with UKCA Marking has been determined to be in compliance with UKCA requirements. The full text of the UK declaration of conformity is available at the following site: https://www.shure.com/en-GB/support/declarations-of-conformity.
UK Importer / UK Rep.
Shure UK Limited
Unit 2, The IO Centre, Lea Road,
Waltham Abbey, Essex, EN9 1 AS,
Waste Electrical and Electronic Equipment (WEEE) Directive
In the European Union and the United Kingdom, this label indicates that this product should not be disposed of with household waste. It should be deposited at an appropriate facility to enable recovery and recycling.
Please consider the environment, electric products and packaging are part of regional recycling schemes and do not belong to regular household waste.
Registration, Evaluation, Authorization of Chemicals (REACH) Directive
REACH (Registration, Evaluation, Authorization of Chemicals) is the European Union (EU) and the United Kingdom (UK) chemical substances regulatory framework. Information on substances of very high concern contained in Shure products in a concentration above 0.1% weight over weight (w/w) is available upon request.